![]() ![]() Then find the specific details about how to configure this backend form the backend specific pages that you can reach by clicking on the links in the table. For the most part this is not a MacOS X specific issue, but a backend specific issue.įirst find out which of the many provided backends that is supposed to support your scanner by consulting the list of supported devices on the SANE project website. The full and complete information about how to configure the SANE backend libraries depends strongly on which of the many backends that supports your scanner. You should first make sure that the SANE libraries work with your scanner. ![]() When trying to make things work, it helps if you are not trying to fix to many things on the same time. The device names on MacOS X are not necessarily invariant between reboots of the computer, so it is essential that autodetection of the device is working. If you have such a scanner try restarting your computer with your scanner turned on.Īnother reason might be that the SANE backend that is used when scanning with your scanner must be configured for your hardware configuration in order to support autodetection. Some scanners - especially older SCSI scanners - from the era before the introduction of plug-and-play devices can not be detected unless they were turned on at the time your computer was started. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |